IBM announced that after five years of work, its researchers have been able to reduce from about one million to 12 the number of atoms required to create a bit of data. The breakthrough may someday allow data storage hardware manufacturers to produce products with capacities that are orders of magnitude greater than today’s hard disk and flash drives.

Looking at this conservatively...instead of 1TB on a device you’d have 100TB to 150TB. Instead of being able to store all your songs on a drive, you’d be able to have all your videos on the device. Today, storage devices use ferromagnetic materials where the spin of atoms are aligned or in the same direction.

The IBM researchers used an unconventional form of magnetism called antiferromagnetism, where atoms spin in opposite directions, allowing scientists to create an experimental atomic-scale magnet memory that is at least 100 times denser than today’s hard disk drives and solid-state memory chips.

While the science behind what IBM researchers accomplished is complex, the results are quite simple: They put a spin on the old adage that “opposites attract.” Instead today’s method for magnetic storage where iron atoms are lined up with the same magnetic polarization, requiring greater distance between them, IBM created atoms with opposite magnetization, pulling them more tightly together.

“Moore’s Law is basically the drive of the industry to shrink components down little by little and then solve the engineering challenges that go along with that but keeping the basic concepts the same. The basic concepts of magnetic data storage or even transistors haven’t really changed over the past 20 years,”. 

Miniaturized information storage in atomic-scale antiferromagnets. The binary representation of the letter 'S' (01010011) was stored in the Neel states of eight iron atom arrays. The researchers started with one iron atom and used the tip of scanning tunneling microscope to switch magnetic information in successive atoms. They worked their way up until eventually they succeeded in storing one bit of magnetic information reliably in 12 atoms. The tip of the scanning tunneling microscope was then used to switch the magnetic information in the bits from a zero to a one and back again, allowing researchers to store information.

IBM used iron atoms on copper nitrate to perform its experiments, but other materials could theoretically require even fewer atoms to store a bit of data. The researchers then combined 86 bits make one byte of data, such as a letter or number. IBM then put many of the bytes together to create information. The first word they spelled using the new technique: T-H-I-N-K, which required five bytes of information or 400 magnetized atoms.

Antiferromagnets is not the only data storage project that IBM is working on. Last year, the company produced its first Racetrack Memory circuit, which could also lead to silicon chips with the capacity of today’s hard drives, but the durability and performance of flash drives. “In the technology world, hopefully this will gather some momentum to allow them to use antiferromagnetic structures as active elements and then solve the all the technological problems around that,”.